Isuzu 1999 RODEO Workshop Manual page 1172

6. Install oil gallery and tighten the bolts in 2 steps in the
order shown.
1st step : 29 N·m (22 lb ft)
2nd step : 55°∼ 65°
7. Install cylinder block side bolts (1) and tighten
crankcase bolts in sequence shown in the illustration.
Torque : 39 N·m (29 lb ft)
ENGINE MECHANICAL (6VD1 3.2L)
8. Install oil pump assembly. Refer to "Oil Pump" in this
manual.
9. Install oil strainer and O-ring.
10. Install oil pipe and O-ring.
11. Install crankcase with oil pan.
1. Completely remove all residual sealant, lubricant
and moisture from the sealing surfaces. The
surfaces must be perfectly dry.
2. Apply a correct width bead of sealant (TB– 1207C
or its equivalent) to the contact surfaces of the
crankcase. There must be no gaps in the bead.
3. The oil pan must be installed within 5 minutes
after sealant application to prevent premature
hardening of sealant.
4. Tighten the bolts and nuts to the specified torque.
Torque : 10 N·m (89 lb in)
012RS007
Legend
(1) Portion Between Both Holes
(2) Bolt Hole Portions
12. Install cylinder head gasket.
13. Install cylinder head assembly. Refer to "Cylinder
Head" in this manual.
012RW005
6A–87
013RW010