22. Remove an E–ring(23) from the pinion shaft using a
flat blade screwdriver.
23. Holding the pinion shaft, push pinion toward the
center bracket and turn the pinion clockwise or
counterclockwise by one tooth of spline, then pull off
the pinion.
24. Remove thrust washer(24).
25. Remove center bracket
26. Remove pinion shaft.
STARTING AND CHARGING SYSTEM (6VD1 3.2L)
Inspection and Repair
Repair or replace necessary parts if extreme wear or
damage is found during inspection.
Armature
Measure the outer diameter of commutator, and replace
with a new one if it is out of the limit.
Standard: 33.0 mm (1.30 in)
Limit: 32.0 mm (1.26 in)
065RW010
Check for continuity between commutator and segment.
Replace commutator if there is no continuity (i.e.,
disconnected).
065RW011
6D3–9
065RS014
065RS015