6A–46
ENGINE MECHANICAL (6VD1 3.2L)
Removal
1. Remove transmission assembly.
f See Transmission section in this manual.
2. Remove flywheel.
3. Remove rear oil seal using a seal remover.
NOTE: Take care not to damage the crankshaft or oil seal
retainer when removing oil seal.
Installation
1. Apply engine oil to oil seal lip and install oil seal using
J-39201.
2. Install flywheel.
f Clean tapped holes in the crankshaft.
f Remove oil on the crankshaft and flywheel
mounting surface.
f Tighten fixing bolts to the specified torque.
NOTE: Do not reuse the bolts and do not apply oil or
thread lock to the bolts.
Torque : 54 N·m (40 lb ft)
Rear Oil Seal
3. Install transmission.
f See Transmission section in this manual.
CAUTION: When assembling the engine and
transmission, confirm that dowels have been
mounted in the specified positions at the engine
side. Take care that dowel positions are different
between the manual transmission and the automatic
transmission.
Otherwise, the transmission may be damaged.
015RS017
015RS018
012RS009