Ignition Coil; Removal; Inspection And Repair; Installation - Isuzu 1999 RODEO Workshop Manual

Removal

1. Disconnect battery ground cable.
2. Ignition coil connector and ignition coil.
f Disconnect three connector from ignition coil.
f Remove harness bracket bolt on cylinder head
cover.
f Remove fixing bolts on ignition coil.
Legend
(1) Ignition Coil Connector
(2) Bolt
(3) Ignition Coil Assembly

Inspection and Repair

Check the ignition coil assembly for insulation. Check
terminals for corrosion or damage, and replace as
necessary.
Measuring resistance of ignition coil assembly.
Terminal No.
1 to 2
1 to 3
2 to 3
Measure resistance of ignition coil assembly, and replace
the ignition coil assembly if its value exceeds the
standard.

Ignition Coil

060RW001
Limit
Without 0 ohm or infinity
maximum ohm.
Same as above
Same as above
IGNITION SYSTEM (6VD1 3.2L)

Installation

1. Install the ignition coil assembly (3).
Connect ignition coil connector (1) and ignition coil
(3), then tighten bolt (2) to the specified torque.
Torque: 4 N·m (35 lb in)
2. Connect battery ground cable.
6D2–3
060RW006
060RW001