Isuzu 1999 RODEO Workshop Manual page 1160

6. Cylinder block side bolts (6)
f Tighten all the bolts to the specified torque in the
order shown.
NOTE: Do not apply engine oil to the crank case side
bolts.
Torque: 39 N·m (29 lb ft)
7. Install oil pump assembly (5), refer to "Oil pump" in
this manual.
8. Install oil strainer and O-ring (4).
9. Install oil pipe and O-ring (3) and tighten the bolts.
Torque: 25 N·m (18 lb ft)
10. Install crankcase with oil pan (2).
1. Completely remove all residual sealant, lubricant
and moisture from the sealing surfaces. The
surfaces must be perfectly dry.
2. Apply a correct width bead of sealant (TB—
1207C or its equivalent) to the contact surfaces of
the oil pan. There must be no gaps in the bead.
3. The crankcase assembly must be installed within
5 minutes after sealant application.
4. Tighten the bolts and nuts to the specified torque.
Torque : 10 N·m (89 lb in)
ENGINE MECHANICAL (6VD1 3.2L)
Legend
(1) Portion Between Bolt Holes
(2) Bolt Hole Portion
11. Install cylinder head assembly, refer to "Cylinder
head" in this manual.
012RS001
6A–75
013RW010