6A–26
ENGINE MECHANICAL (X22SE 2.2L)
3. Set the timing belt shown in the illustration,
ensure that tension side of the timing belt is taut
and move the timing belt tension adjustment lever
clockwise, until the pointer of the tensioner is
flowing.
For used timing belt(over 60 minutes from new):
the pointer will be approx. 4 mm(0.16 in) to the left
of the center of the "V" notch when viewed from
the front of the engine.
For new timing belt: The pointer must be at the
center of "V" notch when viewed from the front of
the engine.
4. Tighten fixing bolt of timing belt tensioner to the
specified torque.
Torque: 25 N·m (18 lb ft)
014RW070
11. Tighten cylinder head cover to the specified torque.
Torque: 8 N·m (5.9 lb ft)
12. Connect camshaft angle sensor connector.
13. Install the ignition cable to spark plug.
14. Install ignition cable cover and tighten two bolts.
Torque: 3 N·m (2 lb ft)
15. Install ventilation hoses to cylinder block side and
cylinder head side.
16. Install timing belt front cover and tighten two bolts to
the specified torque.
Torque: 6 N·m (4.4 lb ft)
014RW069
014RW062
020RW010