Removal; Installation; Control Panel Illumination Bulb - Isuzu 1999 RODEO Workshop Manual

Hide thumbs Also See for 1999 RODEO:

Table of Contents

1A–26 HEATING, VENTILATION AND AIR CONDITIONING (HVAC)

Control Panel Illumination Bulb and

Associated Parts

(1) Control Lever Assembly

(2) Bulb Socket

(3) Illumination Bulb

Resistor and Associated Parts

(1) Duct (Heater only)

(2) Resistor

(3) Resistor Connector

(4) Glove Box

Removal

1. Disconnect the battery ground cable.

2. Remove control lever assembly.

f Refer to Control Lever Assembly in this section.

3. Pull out the bulb socket from the panel by turning it

counterclockwise.

4. Pull the illumination bulb from the socket.

To install, follow the removal steps in the reverse order.

1. Disconnect the battery ground cable.

2. Remove glove box.

3. Remove resistor connector.

4. Remove duct (heater only).

5. Remove resistor.

Installation

To install, follow the removal steps in the reverse order.

Show Quick Links

Table of Contents

Do you have a question about the 1999 RODEO and is the answer not in the manual?