Isuzu 1999 RODEO Workshop Manual page 534

8. Install timing belt tensioner then tighten it temporarily
until make alignment timing belt.
9. Install the cylinder head cover and tighten fixing bolt
temporally.
10. Install the timing belt and perform timing belt setting
procedure as follows.
1. Bring the engine top dead center No.1 cylinder
compression stroke by rotating the engine in the
direction of normal operation.
The engine is in this position when the notches on
the camshaft pulleys align with the marks on the
cylinder head cover(1), Check the crankshaft
pulley timing mark is aligned (2) also check for
water pump positioning ensure tabs are aligned
(3).
f Rotate the engine two full turns in the direction
of normal operation until the engine is again at
top dead centre, No.1 cylinder firing being
careful that all movement is in a clockwise
direction.
f If the engine is turned too far, do not turn
backwards, but continue to turn in the same
direction until the marks are again in line.
ENGINE MECHANICAL (X22SE 2.2L)
020RW016
2. Place J–43037 to between intake and exhaust of
camshaft drive gear to prevent camshaft drive
gear movement during timing belt setting.
014RW067
6A–25
014RW066
014RW063
014RW065