Mazda RX-8 Workshop Manual page 3400

2011 - rx-8
Hide thumbs Also See for RX-8:
Table of Contents

Advertisement

(See
DIAGNOSTIC CHECK [CAR-
NAVIGATION
Drive the vehicle.
Check the "GPS Antenna" on the
diagnosis screen.
Is the "OK" indicated?
NOTE:
If the engine started after diagnostic
function activated, the diagnostic
function is reset.
9
Turn the ignition switch to the LOCK
position.
Inspect the connection of the car-
navigation unit connector (3-pin) and
GPS antenna connector.
Is the connector securely connected?
10
Disconnect the GPS antenna and car-
navigation unit connector for poor
connection (such as damaged/pulled
out pins, corrosion).
Are all pins normal?
SYSTEM].)
No Go to the next step.
YesGo to the next step.
No Securely connect the suspect connector.
YesGo to the next step.
No
If the car-navigation
unit connector is
wrong:
Replace the car-navigation
unit.
(See
CENTER PANEL UNIT
REMOVAL/INSTALLATION).
(See
CENTER PANEL UNIT
DISASSEMBLY/ASSEMBLY).
If the GPS antenna
connector is wrong:
Replace the GPS antenna.
(See
GPS ANTENNA
REMOVAL/INSTALLATION.)
If the wiring harness-
side connector is
wrong:
Repair or replace the pins
and/or the connector.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2011 rx-8

Table of Contents