Table 8-39: Cable Detect And Remote Powered Status - Epson S1D13506 Technical Manual

Page 174
bit 7
bit 6
bit 5
Cable Detected
Status [bit 7]
bit 4
bit 3
bit 2
bit 1
bit 0
S1D13506
X25B-A-001-12
Cable Detected Status (MediaPlug Parameter Rstat)
The cable detected status as determined by the MPD(1) pin.
When this bit = 0, a MediaPlug cable is connected.
When this bit = 1, a MediaPlug cable is not detected.
A write to this bit has no hardware effect.
A read from this bit will always return 0b.
A write to this bit has no hardware effect.
Remote Powered Status (MediaPlug Parameter Rstat)
The remote powered status as determined by the RCTRL pin.
When this bit = 0, the remote is not powered.
When this bit = 1, the remote is powered and connected.
A write to this bit has no hardware effect.

Table 8-39: Cable Detect and Remote Powered Status

Remote Powered
Status [bit 5]
0 0
0 1
1 x
A read from this bit will always return 0b.
A write to this bit has no hardware effect.
MediaPlug Interface Clock Enable (MediaPlug Parameter IC)
When this bit = 0, the MediaPlug interface clock is enabled (default).
When this bit = 1, the MediaPlug interface clock is disabled.
MediaPlug Clock (MediaPlug Parameter MC)
When this bit = 0, the MediaPlug cable clock is disabled (default).
When this bit = 1, the MediaPlug cable clock is enabled.
Power Enable to Remote (MediaPlug Parameter P)
When this bit = 0, power to remote is off (default).
When this bit =1, power to remote is on.
Watchdog Disable (MediaPlug Parameter W)
When this bit = 0, the MediaPlug watchdog is enabled (default).
When this bit = 1, the MediaPlug watchdog is disabled.
Status
cable connected but remote not powered
cable connected and remote powered
cable not connected
Epson Research and Development
Vancouver Design Center
Hardware Functional Specification
Issue Date: 02/03/26