Epson S1D13506 Technical Manual page 450

Page 8
S1D13506
X25B-B-004-02
ERROR: Not enough memory for LCD/CRT/TV in 4/8/15/16 bits-per-pixel.
13506BMP is unable to change the color depth due to insufficient display buffer memory. Memory
requirements depend on:
• the display resolution(s).
• the bit-per-pixel depth(s).
• whether a half-frame buffer is required.
• the number of displays active (LCD or LCD and CRT/TV).
ERROR: Not enough memory for virtual display.
A virtual display is required for SwivelView
memory for the given configuration. Memory requirements depend on:
• the display resolution(s).
• the bit-per-pixel depth(s).
• whether a half-frame buffer is required.
• the number of displays active (LCD or LCD and CRT/TV).
ERROR: PCI bridge adapter not found.
The Windows PCI driver did not find the PCI Bridge Adapter.
ERROR: PCI driver not found.
The Windows PCI driver is not loaded.
ERROR: Program not configured for LCD/CRT/TV. Run 13506CFG and configure for
LCD/CRT/TV.
The program was configured by 13506CFG for a display device that is not available. This typically
occurs if the wrong command line was entered for the current configuration.
WARNING: CLKI frequency not in HAL table. Program assumes that external oscillator is
used.
WARNING: CLKI2 frequency not in HAL table. Program assumes that external oscillator is
used.
The correct frequency was not found in the HAL table used to program the clock synthesizer. An
external oscillator may be in use. This warning message will not stop the program.
WARNING: CRT/TV only available in LANDSCAPE mode.
SwivelView™ is only available on LCD only configurations.
Epson Research and Development
™
. This error message indicates there is insufficient
13506BMP Demonstration Program
Vancouver Design Center
Issue Date: 01/02/06