Epson S1D13506 Technical Manual page 427

Epson Research and Development
Vancouver Design Center
Program Messages
13506SHOW Demonstration Program
Issue Date: 01/02/06
ERROR: Could not detect S1D13506.
The ID register did not indicate the presence of the 13506.
ERROR: Could not map memory from evaluation board to host platform.
This message should only be shown for DOS platforms. In this case the DOS extender could not be
initialized, or was unable to get the linear address of the display memory.
ERROR: In the given display surface configuration, the user must select the same BPP for
both LCD and CRT/TV.
When two displays are using an image from the same display memory block, both displays must be
configured for the same color depth (bpp).
ERROR: Invalid display surface number.
The "ds=" command line option included an invalid value. The parameter "ds=?" lists the valid
numbers.
ERROR: LCD and CRT resolutions must be identical.
LCD: (width, height)
CRT: (width, height)
When the LCD and CRT are using an image from the same display memory block, both displays
must be the same resolution.
ERROR: LCD and TV resolutions must be identical.
LCD: (width, height)
TV: (width, height)
When the LCD and TV are using an image from the same display memory block, both displays must
be the same resolution.
ERROR: LCD must be in landscape mode.
The LCD panel must be configured for SwivelView 0° mode (landscape) if both the LCD display
and CRT/TV are active.
ERROR: Not enough display buffer memory.
There was insufficient display buffer memory for the given configuration. Memory requirements
depend on:
• the display resolution(s).
• the bit-per-pixel depth(s).
• whether a half-frame buffer is required.
• the number of displays active (LCD or LCD and CRT/TV).
Page 9
S1D13506
X25B-B-002-03