Epson S1D13506 Technical Manual page 441

Epson Research and Development
Vancouver Design Center
Program Messages
13506PLAY Diagnostic Utility
Issue Date: 01/02/06
ERROR: Could not map memory from evaluation board to host platform.
This message should only be shown for DOS platforms. In this case the DOS extender could not be
initialized, or was unable to get the linear address of the display memory.
ERROR: Not enough display buffer memory.
There was insufficient display buffer memory for the given configuration. Memory requirements
depend on:
• the display resolution(s).
• the bit-per-pixel depth(s).
• whether a half-frame buffer is required.
• the number of displays active (LCD or LCD and CRT/TV).
ERROR: Not enough memory for LCD/CRT/TV in 4/8/16 bits-per-pixel.
13506BMP is unable to change the color depth due to insufficient display buffer memory. Memory
requirements depend on:
• the display resolution(s).
• the bit-per-pixel depth(s).
• whether a half-frame buffer is required.
• the number of displays active (LCD or LCD and CRT/TV).
ERROR: PCI bridge adapter not found.
The Windows PCI driver did not find the PCI Bridge Adapter.
ERROR: PCI driver not found.
The Windows PCI driver is not loaded.
ERROR: Program not configured for LCD/CRT/TV. Run 13506CFG and configure for
LCD/CRT/TV.
The program was configured by 13506CFG for a display device that is not available. This typically
occurs if the wrong command line was entered for the current configuration.
WARNING: CLKI frequency not in HAL table. Program assumes that external oscillator is
used.
WARNING: CLKI2 frequency not in HAL table. Program assumes that external oscillator is
used.
The correct frequency was not found in the HAL table used to program the clock synthesizer. An
external oscillator may be in use. This warning message will not stop the program.
ERROR: At least one of the displays must be enabled.
This message is shown when 13506PLAY received the V command, but no display is enabled. At
least one display must be enabled for the V command to function (5 seconds of VNDP pulses are
counted to calculate the frame rate).
ERROR: Invalid iFreq value.
The CLKI and/or CLKI2 commands were used with an invalid iFreq value. To display a list of iFreq
values, type "CLKI ?" or "CLKI2 ?".
Page 13
S1D13506
X25B-B-003-02