Epson S1D13506 Technical Manual page 434

Page 6
S1D13506
X25B-B-003-02
FW addr addr data...
Fills a specified address range with 16-bit data (words).
Where:
addr
data
H [lines]
Sets the number of lines of data that will be displayed at a time. The display will be halted
after the specified number of lines. Setting the number of lines to 0 will disable the halt
function and allow the data to continue displaying until all data has been shown.
Where:
lines
I [?] {LCD|CRT|TV} [d=iCrtTv] [COMP | SVIDEO] [FLICKER=ON | OFF]
Initializes the S1D13506 registers for a given display type.
Where:
?
LCD
CRT
TV
d = iCrtTv
iCrtTv
COMP
SVIDEO
FLICKER=ON
FLICKER=OFF
Address range to be filled (hex).
Data to be written (hex). Data can be a list of words that will
be repeated for the duration of the fill. To use decimal
values, attach a "t" suffix to the value. (e.g. 100t is 100
decimal).
Number of lines that will be shown before halting the
displayed data (decimal value).
Displays a help message.
Initializes the LCD registers.
Initializes the CRT registers.
Initializes the TV registers.
Initializes the CRT/TV for a display configuration based on
the following table.
Table 1: iCrtTv Selection
Resolution
0 640x480
1 800x600
2 752x484
3 696x436
4 640x480
5 920x572
6 856x518
7 800x572
8 640x480
Initializes for Composite video output (TV only).
Initializes for SVideo output (TV only).
Initializes for Flicker Filter enabled (TV only).
Initializes for Flicker Filter disabled (TV only).
Epson Research and Development
Vancouver Design Center
Display Type
CRT
CRT
TV (NTSC)
TV (NTSC)
TV (NTSC)
TV (PAL)
TV (PAL)
TV (PAL)
TV (PAL)
13506PLAY Diagnostic Utility
Issue Date: 01/02/06