Base Reference Point - SATO HR2 Series Operator's Manual

Section 8: Appendix

8.3 BASE REFERENCE POINT

The base reference point is the point at which one determines the print and cut positions.
The base reference position differs, depending on the print mode or the label pitch sensor to be used.
8.3.1 Continuous Mode
The base position for printing in continuous mode.
.
Base position
for printing
8.3.2 Tear-off Mode
The base position for printing and manual cutting in Tear-off mode.
Base position
for tear-off/printing
8.3.3 Dispenser Mode
The base position for printing and dispensing in Dispenser mode.
Base position
for printing
Base position
for dispensing
Page 8-4
GAP
GAP
Base position
for tear-off/printing
GAP
Base position
for dispensing/
printing
Base position
for printing
I-Mark
I-Mark
I-Mark
HR2 Series Operator Manual