Show/Monitor/List Ip - Lantronix SCS Reference Manual

Command Reference

12.5.35 Show/Monitor/List IP

⎧ ⎫
SHOW
⎪ ⎪
⎨ ⎬
PROTOCOLS IP
MONITOR
⎪ ⎪
⎩ ⎭
LIST
Displays the current operating characteristics of the targets. Use the List command to see the permanent
attributes that will take effect upon reboot/login.
Restrictions
Parameters
Bit Connect Failure
Reasons
0 Internal failure, should be 0
1
2 No nameserver defined (for
text host name)
3 Attempted name service
failed
4 No gateway was configured
for a non-local connection
COUNTERS
HASHTABLE
INTERFACES ETHERNET num
You must be the privileged user to use the Monitor command.
[No Parameters]
Entering the Show IP command without additional keywords will display
general IP protocol information, including the following counters.
The Reasons fields show counters in hexadecimal with the rightmost bit being
0. For example, a Connect Failure Reason of 0040 represents 0000 0000 0100
0000 in binary, which means that bit 6 is set. The meaning of each bit is
explained in Table 12-1.
Table 12-1: IP Failure and Message Reasons
Invalid Packet
Reasons
Data received outside
window
Connection terminated
abnormally
Packet received with an
invalid data checksum
Packet received with an
invalid data header
RST packet sent to remote
node
12-49
ALL
ARP
CACHE
SiteName
NAT
ROUTES
SECURITY
TRUSTED
ICMP Message
Reasons
Echo message received
Echo reply received
Destination unavailable; see
bits 4-7
Unknown ICMP type
received
Network unreachable;
usually from a gateway host
IP/Network Commands