Set/Define Ports Session Limit; Set/Define Ports Signal Check - Lantronix SCS Reference Manual

Command Reference
Defaults
See Also

12.6.44 Set/Define Ports Session Limit

⎧ ⎫
SET PORTS PortList
⎨ ⎬
⎩ ⎭
DEFINE
Limits the number of active sessions on a port. The maximum number of session configured for a port
cannot exceed the server session limit.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
See Also

12.6.45 Set/Define Ports Signal Check

⎧ ⎫
SET PORTS PortList
⎨ ⎬
⎩ ⎭
DEFINE
Determines whether or not the DSR signal will be checked for when remote connections to the port are
made. If enabled, remote connections to the port will not be permitted unless the DSR signal is asserted.
number
The maximum size, in KB, of the log file. Enter an integer between 0 and 250.
A value of 0 turns logging off.
No logging
Set/Define Ports Access, page 12-57; Define Email, page 12-55; Define Ports
Event Email Serialdata, page 12-71; Event Port Logging, page 12-2
⎧
⎨
SESSION LIMIT
⎩
ALL
Requires privileged user status.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
limit
An integer between 0 and 8.
None
Allows the maximum number of sessions.
Limit: 4 sessions
Set/Define Server Session Limit, page 12-126; Port-Specific Session
Configuration, page 8-4
SIGNAL CHECK
ALL
12-86
⎫
limit
⎬
⎭
NONE
⎧ ⎫
ENABLED
⎨ ⎬
⎩ ⎭
DISABLED
Port Commands