Set/Define Ports Verification; Set Privileged/Noprivileged - Lantronix SCS Reference Manual

Command Reference
Defaults
See Also

12.6.54 Set/Define Ports Verification

⎧ ⎫
SET PORTS PortList
⎨ ⎬
⎩ ⎭
DEFINE
When enabled, the server will issue informational messages whenever a session is connected, disconnected,
or switched.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
See Also

12.6.55 Set Privileged/Noprivileged

⎧
⎪
PRIVILEGED OVERRIDE
⎨
SET
⎪
NOPRIVILEGED
⎩
Changes the current port's privilege status. Only one port on the server can be privileged at any time. The
Override parameter is provided to force your current port to become the privileged port (and the previously
privileged port loses the privilege).
When changing your port to privileged status, you will be queried for the privileged password. The factory
default privileged password is system; this password can be changed with the Set Server Privileged
Password command. If the password is forgotten, the server can be reset to factory defaults using the
Initialize commands.
Restrictions
Examples
None
Specifying a Username, page 8-13
⎧
⎨
VERIFICATION
⎩
ALL
Requires privileged user status if you wish to use this command on ports other
than your own.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Enabled
Port-Specific Session Configuration, page 8-4
⎫
⎪
⎬
⎪
⎭
To use the Privileged parameter, you must know the privileged password.
Secure users cannot become privileged.
Local>> SET NOPRIVILEGED
Local>> SET PRIVILEGED OVERRIDE
12-92
⎫
ENABLED
⎬
⎭
DISABLED
Port Commands