Lantronix SCS Reference Manual page 348

Command Reference
See Estimate Each Port's Bandwidth on page 5-6 for more information on how
Note:
to use the port bandwidth setting.
Defaults
Examples
See Also
Bandwidth
Gives the SCS a bandwidth estimate for the device (for example, a modem)
that is attached to the port. Must be used in conjunction with the
BytesPerSecond parameter.
BytesPerSecond
The bandwidth value. The value can range from 100 to 6,550,000 bytes per
second.
Telephone
Specifies a telephone number for this port. This number will override the
number defined for the site as a whole. Must be used in conjunction with either
the number parameter or the None parameter.
number
A telephone "number" of up to 24 characters (characters can be of any type).
None
No specific telephone number will be set for this port.
Priority
Specifies a priority level for a particular port. Higher priority ports will be
dialed before ports with lower priority numbers. Must be used with the
prioritynum parameter.
priorityNum
An integer between 1 and 100 representing the priority level of the specified
port.
Bandwidth: 100 bytes per second
Local>> DEFINE SITE irvine PORT 2 TELEPHONE "8675309"
Local>> DEFINE SITE irvine PORT 2 BANDWIDTH 28800
Define Site Bandwidth, page 12-134; Show/Monitor/List Sites, page 12-149;
How Bandwidth is Controlled, page 5-5
12-144
Site Commands