Set/Define Ip Timeserver - Lantronix SCS Reference Manual

Secure console servers
Table of Contents

Advertisement

Command Reference

12.5.30 Set/Define IP Timeserver

SET
PROTOCOLS IP TIMESERVER
DEFINE
Configures a timeserver for the SCS to use to update its internal clock. The SCS can communicate with
either Daytime or Network Timeserver Protocol (NTP) servers. For NTP, the SCS can periodically
broadcast a message asking for time information and wait for an NTP timeserver to reply, periodically query
a specific NTP timeserver, or just listen for NTP broadcasts on the network.
Restrictions
Parameters
Daytime is only supported over UDP.
Note:
Examples
DAYTIME address
NTP
Requires privileged user status.
Daytime
Specifies a daytime server. The SCS will listen for a possible daytime server,
then send packets querying that server for time information.
address
An IP address in standard numeric format (for example, 193.0.1.50).
None
Clears a previous timeserver setting.
NTP
Specifies an NTP server. There are three types of NTP.
Broadcast
The SCS periodically broadcasts a message that asks for time information, and
waits for an NTP timeserver to reply.
IP
Use this method if you have a single NTP timeserver on your network. You
must enter an IP address in standard numeric format.
Passive
The SCS will listen for NTP timeserver announcements on the network.
DEFINE IP TIMESERVER NTP IP 192.0.1.122
12-46
BROADCAST
IP ipaddress
PASSIVE
NONE
IP/Network Commands

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SCS and is the answer not in the manual?

Questions and answers

Table of Contents