Table of Contents
Advertisement
Monitor mode and Firmware Upgrade
5
Monitor Mode and Firmware Upgrade
To enter monitor mode, the same principal as setting the parameters is used (see
4.4 Serial Configuration). Instead of entering three "x " keys, key in "xx1". The
UTS will respond with a special prompt. A UTS Token Ring needs a working
network connection to enter monitor mode. Because Network functions are
needed for some diagnostics commands, it may take up to 20 seconds until the
network part of the UTS is initialized and the prompt is displayed. This is
especially true if an empty Token Ring (or a ring simulator) is used. For a
simple ring simulator, see Appendix B. To start the monitor mode without
network functions, enter "xx2" (new function with Version 2.05 and later).
5.1
Monitor Commands
The following commands are available in the monitor mode. Many commands
have an IP address as an optional parameter (x.x.x.x). If it is given, the
command is applied to another UTS with that IP address. If no IP address is
given, the command is executed locally.
All commands must be given in capital letters; only blanks (spaces) are
accepted between parameters.
DL
SF x.x.x.x
VS x.x.x.x
GC x.x.x.x
SC x.x.x.x
PI x.x.x.x
QU
Command result codes:
0
1
2
8
9
Firmware download to the UTS
Send irmware to UTS with IP x.x.x.x
Query software header record (16-byte).
Get configuration as HEX records
Set configuration from HEX records
Check with Ping if x.x.x.x is alive and reachable.
Quit - exit diagnostics mode
OK, no error
No answer from remote device
Cannot reach remote device or does not answer
Wrong parameter(s)
Invalid command
5-1
Advertisement
Table of Contents
