Set/Define Ports Autoconnect - Lantronix SCS Reference Manual

Command Reference
Restrictions
Errors
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
Examples
See Also

12.6.13 Set/Define Ports Autoconnect

⎧ ⎫
SET PORTS PortList
⎨ ⎬
⎩ ⎭
DEFINE
If enabled, the port connects automatically to the preferred service upon login. To exit to character (Local>
) mode, the Break command can be used. To attach other services, the Connect command can be used.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
Examples
See Also
Requires privileged user status.
Autobaud and Autostart cannot be used together. If you try to configure both
options, you will get a message saying that the previously configured option
was disabled.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Autobaud works for most baud rates when both ends of the line are the same
parity, or when the port is set to 8 bits with no parity and the incoming
connection is 7 bits with even parity. Baud rates must be within 3 "steps" of
each other, 9600 to 38400 will work, but 9600 to 115200 will not.
Disabled
Local>> DEFINE PORTS AUTOBAUD DISABLED
Configure Modems, page 4-18; Modem Speeds, page 9-2
⎧
⎨
AUTOCONNECT
⎩
ALL
Requires privileged user status to use this command on ports other than your
own. Secure users may not use this command.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Disabled
Local>> SET PORTS AUTOCONNECT ENABLED
Set/Define Ports Preferred, page 12-79
12-59
⎫
ENABLED
⎬
⎭
DISABLED
Port Commands