Set/Define Ports Loss Notification - Lantronix SCS Reference Manual

Command Reference
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
Examples
See Also

12.6.31 Set/Define Ports Loss Notification

⎧ ⎫
SET PORTS PortList
⎨ ⎬
⎩ ⎭
DEFINE
Sends the terminal device a Ctrl-G (Bell) when a typed character is lost due to a data error or an overrun on
the SCS.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
Defaults
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Switch
Defines the control character. Must be used in conjunction with the character
parameter.
character
The character to be used as the local switch. To specify a control character, use
escaped hex (\xx). For example, Ctrl-B (ASCII character 0x02) would be
specified as \02.
None
Clears the current switch character.
None configured for serial connections; \0c (Ctrl-L) for virtual port logins
Local>> SET PORT 2 LOCAL SWITCH \02
Set/Define Ports Break, page 12-62; Set/Define Ports Backward Switch, page
12-61; Set/Define Ports Forward Switch, page 12-73; Port-Specific Session
Configuration, page 8-4
LOSS NOTIFICATION
ALL
Requires privileged user status if you want to use this command on a port other
than your own. Secure users may not use this command.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Enabled
Enabled
12-75
⎧ ⎫
ENABLED
⎨ ⎬
⎩ ⎭
DISABLED
Port Commands