Define Ports Modem Callerid; Define Ports Modem Carrierwait - Lantronix SCS Reference Manual

Command Reference

12.4.4 Define Ports Modem CallerID

DEFINE PORTS PortList
ALL
Configures whether the SCS will look for and attempt to decode Caller-ID information for incoming calls.
The SCS should be set to wait for three rings before answering the line so that it has enough time to gather
the Caller-ID information. The ring setting can be configured with the Rings command.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
See Also

12.4.5 Define Ports Modem Carrierwait

DEFINE PORTS PortList
ALL
Defines the length of time that a server will wait for a carrier on incoming and autodialed calls. If a carrier
is not received in that length of time, the SCS assumes that it will not be received. The call will fail and the
modem will be reset.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
⎧
⎨
MODEM CALLERID
⎩
Requires privileged user status.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Disabled
Define Ports Modem Answer, page 12-3; Caller-ID, page 9-12
MODEM CARRIERWAIT
Requires privileged user status.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
seconds
A time value between 1 and 250 seconds.
60 seconds
12-5
⎫
ENABLED
⎬
⎭
DISABLED
sec onds
Modem Commands