Set/Define Service Banner; Set/Define Service Binary; Set/Define Service Eoj - Lantronix SCS Reference Manual

Command Reference

12.7.4 Set/Define Service Banner

⎧ ⎫
SET
⎨ ⎬
SERVICE ServiceName BANNER
⎩ ⎭
DEFINE
Specifies whether the SCS should print a banner page before starting the job. Banners should be disabled
(the default) for all PostScript and plotter (binary) data.
Restrictions
Defaults
See Also

12.7.5 Set/Define Service Binary

⎧ ⎫
SET
⎨ ⎬
SERVICE ServiceName BINARY
⎩ ⎭
DEFINE
If the binary characteristic is enabled on a service, character translation (i.e. <cr> to <cr><lf> translation)
and tab expansion will be permitted on the print data. The binary characteristic should be disabled when
printing PCL data.
Restrictions
Defaults
See Also

12.7.6 Set/Define Service EOJ

⎧ ⎫
SET
⎨ ⎬
SERVICE ServiceName EOJ
⎩ ⎭
DEFINE
Specifies a string to be sent to the attached device at the end of every job regardless of network protocol.
Restrictions
Parameters
⎧
ENABLED
⎨
⎩
DISABLED
Requires privileged user status.
Enabled
Clear/Purge Service, page 12-101
⎧
ENABLED
⎨
⎩
DISABLED
Requires privileged user status.
Disabled
Clear/Purge Service, page 12-101
⎧
EndString
⎨
⎩
NONE
Requires privileged user status.
EndString
Any ASCII characters, or non-ASCII characters entered as hexadecimal digits
(e.g. \45). The combined length of the SOJ and EOJ strings must not exceed 62
characters.
12-103
⎫
⎬
⎭
⎫
⎬
⎭
⎫
⎬
⎭
Service Commands