Set/Define Ports Flow Control - Lantronix SCS Reference Manual

Command Reference
When email notification is enabled, an email is triggered when the specified serial port receives a burst of
20 or more characters in its serial log. The port will buffer the incoming data for up to 25 seconds or until
the log file reaches 1500 bytes before sending the email, which contains the current contents of the log file.
Any data that comes in after that 25 seconds will be discarded. Email can not be sent from the same port
more than once every 10 minutes.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
See Also

12.6.27 Set/Define Ports Flow Control

⎧ ⎫
SET PORTS PortList
⎨ ⎬
⎩ ⎭
DEFINE
Sets the type of flow control on the port.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Requires privileged user status.
Port buffering must be enabled (Set/Define Ports Serial Log) for email
notification to work.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
set to None
Set/Define Ports Serial Log, page 12-85; Define Email, page 12-55; Event Port
Logging, page 3-2; Email Alerts for Serial Events, page 3-3
FLOW CONTROL
ALL
Requires privileged user status if you want to use this command on ports other
than your own. Secure users may not use this command.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
None
No flow control will be performed.
CTSRTS
Sets the flow control type to RTS/CTS.
XONXOFF
Sets the flow control type to XON/XOFF.
12-72
⎧ ⎫
NONE
⎪ ⎪
⎨ ⎬
CTSRTS
⎪ ⎪
⎩ ⎭
XONXOFF
Port Commands