Displaying Existing Sites; Editing Sites - Lantronix SCS Reference Manual

Basic Remote Networking
Characteristic
Remote host's IP configuration
IP compression slots
Maximum packet size (MTU): PPP
Ports defined
PPP
SLIP
Telephone number of remote site
Outgoing packet filter
Incoming packet filter
Idle time filter
Startup filter
Maximum packet size (MTU): SLIP
Maximum session time

4.2.2 Displaying Existing Sites

To display all defined sites, use the List Site command. To display currently active sites, use the Show Site
command.
To display specific information about sites, the following parameters may be used in conjunction with Show
Site and List Site: IP, Ports, Counters, and Status. For example, to display the IP configuration of site irvine,
use the following command:
Local>> LIST SITE IRVINE IP
The List Site command is used in Figure 4-5 because site irvine isn't currently
Note:
running.

4.2.3 Editing Sites

All site characteristics can be edited with the Define Site commands. For example, a site's authentication
can be edited with the command below.
Local>> DEFINE SITE irvine AUTHENTICATION PAP DISABLED
Site Commands are discussed on page 12-132.
Note:
Currently active sites can be edited, but changes will not take effect until the site is logged out.
Table 4-1: Default Site Configuration
Figure 4-5: Displaying a Site's IP Configuration
Figure 4-6: Editing Site Characteristics
4-4
Managing Connections With Sites
Configuration in Default Site
Undefined
16
1522
None
Enabled
Disabled
None defined
None defined
None defined
None defined
None defined
1500
Disabled