Lantronix SCS Reference Manual page 345

Command Reference
Metric is commonly used to make a given interface less desirable for backup
Note:
routing situations.
Dynamic
Allows the SCS to be dynamically assigned an IP address by a remote host.
Default
Advertises this server as the default route to the remote host.
Netmask
Sets the IP Netmask on this server's IP interface.
mask
A value that is used to remove bits that you do not want.
Remoteaddress
Sets the IP address (specified with the address parameter) of the remote host.
If two address are specified, it indicates an acceptable range of addresses for
the remote host.
Callers cannot use IP addresses with the host part of the address set to zero or
-1; these addresses are reserved for broadcast packets. If the specified range
includes such an address (for example, 192.4.5.0 or 192.4.5.255) and a caller
requests this address, the connection will be denied.
address
An IP address in standard numeric format. For example, 192.0.1.3.
None
Clears a current IP address, Remoteaddress address, Othermask, or Netmask.
Unnumbered
An IP address is not to be expected from the remote site.
RIP
Enables or disables RIP parameters, and allows specification of update times
and hop counts for the interface.
Enabled/Disabled
Enables or disables both listen and send at the same time.
Listen
Enables or disables RIP listening only.
Send
Enables or disables RIP sending only.
Metric
Configures the cost ("hop-count") of this interface. Routes learned through this
interface will have this value added to their metric. Must be used in conjunction
with the cost parameter.
cost
An integer between 1 and 16.
12-141
Site Commands