Set/Define Ports Break - Lantronix SCS Reference Manual

Command Reference
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
Examples
See Also

12.6.16 Set/Define Ports Break

⎧ ⎫
SET PORTS PortList
⎨ ⎬
⎩ ⎭
DEFINE
Allows users to set an alternate Break character, and determines where the Break condition is processed.
Examples of using the Break key/character with the Local and Remote settings can be found on page 8-5.
Restrictions
Parameters
Requires privileged user status if you want to use this command on ports other
than your own.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Switch
Defines the control character. Must be used in conjunction with the character
parameter.
character
The character to be used as the backward switch. To specify a control
character, use escaped hex (\xx). For example, Ctrl-B (ASCII character 0x02)
would be specified as \02.
None
Clears the current switch character.
None configured for serial connections; \02 (Ctrl-B) for virtual port logins
Local>> SET PORT 2 BACKWARD SWITCH \02
Backwards, page 12-180; Set/Define Ports Forward Switch, page 12-73; Set/
Define Ports Local Switch, page 12-74; Switching Between Sessions, page 8-5
⎧
⎪
⎪ CHARACTER
⎪
⎨
BREAK
⎪
ALL
⎪
REMOTE
⎪
⎩
Requires privileged user status if you want to use this command on ports other
than your own. Secure users may not use this command.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
⎫
⎪
char
⎪
NONE ⎪
⎬
LOCAL
⎪
⎪
⎪
⎭
NONE
12-62
Port Commands