Set/Define Ports Command Completion - Lantronix SCS Reference Manual

Command Reference
Restrictions
Errors
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
Examples
See Also

12.6.20 Set/Define Ports Command Completion

⎧ ⎫
SET PORTS PortList
⎨ ⎬
⎩ ⎭
DEFINE
Enables or disables the command completion feature. If enabled, the SCS will attempt to complete partially-
typed command words when the user presses the Space or Tab keys.
Restrictions
Errors
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
Examples
Requires privileged user status if you want to use this command on ports other
than your own. Secure users may not use this command.
Autobaud only works for 8 bits, or for 7 bits with even parity.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
7 or 8
Character size must be either 7 or 8 bits.
8 bits
Local>> SET PORTS CHARACTER SIZE 7
Set/Define Ports Autobaud, page 12-58; Set/Define Ports Parity, page 12-77;
Chapter 9, Modems
COMMAND COMPLETION
ALL
Requires privileged user status if you want to use this command on ports other
than your own.
If the partially-entered command is ambiguous (or if you are typing an optional
string), the SCS sends a beep to the terminal.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Disabled
Local>> SET PORTS COMMAND ENABLED
⎧
ENABLED
⎨
⎩
DISABLED
12-65
Port Commands
⎫
⎬
⎭