Lantronix SLC 8000 Demo Manual

Lantronix SLC 8000 Virtual Demo Guide
Introduction
Thank you for your interest in the Lantronix SLC 8000 and for trying out the SLC 8000 virtual demo. Here
a few tips to help make the most out of your experience.
The SLC 8000 virtual demo starts off with the unit in a factory default state. Because you may want to
try connecting to a console, there are few settings you may want to configure right away.
Device Ports 1-4 on this demo are connected to simulated serial console ports to allow you to
experience a connection to a remotely managed device. The following steps will allow you to open a
web based SSH session to those console ports.
Additional suggestions will allow you to then look at a log of your session.
NOTE: The demo SLC has a self-signed SSL certificate. At any time when you are opening an SSL based
connection, it is not unexpected to get a security warning. Allow the session to proceed in those cases.
IMPORTANT: The Web SSH client on the SLC requires that the Java plug-in be installed on your browser.
Go to www.java.com for more information on installing Java.
© Lantronix, Inc. 2014. All rights reserved. Lantronix and PremierWave are registered trademarks of Lantronix in the U.S. and other countries. SLC, vSLM, SLP, and Connect Smart.
Do More., are trademarks of Lantronix, Inc. Windows is a registered trademark of Microsoft Corporation in the U.S. and other countries. All other trademarks are the property of
their respective owners. Specifications subject to change without notice.