Set/Define Ports Dtrwait; Define Ports Event Email Serialdata - Lantronix SCS Reference Manual

Command Reference
Errors
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
See Also

12.6.25 Set/Define Ports DTRWait

⎧ ⎫
SET PORTS PortList
⎨ ⎬
⎩ ⎭
DEFINE
If enabled, the SCS will not assert the DTR signal on the serial port until a user logs into the port, connects
to the port via a service, or connects to the port via a Telnet connect. When the port is idle, DTR will not be
asserted.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
See Also

12.6.26 Define Ports Event Email Serialdata

DEFINE PORTS PortList
ALL
Enables email notification for the serial buffering feature. This command automatically changes the
specified port's access to Remote if not already set.
Modem Control and DSRLogout are mutually exclusive.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Disabled
DSR Logouts, page 8-11; Serial Signals, page 8-20
⎧
ENABLED
⎨
DTRWAIT
⎩
ALL DISABLED
Requires privileged user status.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Disabled
Define Ports Modem Control, page 12-8; Set/Define Ports Flow Control, page
12-72; DTR (Data Terminal Ready), page 8-22
EVENT EMAIL SERIALDATA
12-71
⎫
⎬
⎭
⎧ ⎫
ENABLED
⎨ ⎬
⎩ ⎭
DISABLED
Port Commands