Define Ports Ppp - Lantronix SCS Reference Manual

Command Reference

12.6.39 Define Ports PPP

DEFINE PORTS PortList
Enables PPP to run on the specified port and configures PPP-related settings. This command does not start
PPP. You can use this command to specify a per port username and password to authenticate information
outbound from the SCS, for example, CHAP Secrets. If you do not specify the per port fields, the username
and password from the appropriate site is used for the connection.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
⎧
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎨
PPP
⎪
COUNTER
ALL
⎪
⎪
⎪
⎪
HEADERCOMPRESSION
⎪
⎪
MAGICNUMBER
⎪
⎪
PROTOCOLCOMPRESSION
⎪
⎪
⎪
MULTILINK
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎩
Requires privileged user status.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Enabled/Disabled
Enables or disables PPP on a specified port, but does not start PPP.
Dedicated
Configures a port to always be in PPP mode. The port will automatically run
PPP when it is started. No other protocol can be run on the port; it will continue
to run until it is logged out.
ENABLED
DISABLED
DEDICATED
⎧ ⎫
map
⎨ ⎬
ACCM
⎩ ⎭
XONXOFF
⎧ ⎫
⎪ BOTH ⎪
⎪ ⎪
CHAP LOCAL
⎨ ⎬
⎪ ⎪
PAP REMOTE
⎪ ⎪
DISABLED
⎩ ⎭
⎧ ⎫
CONFIGURE
⎪ ⎪
⎨ ⎬
num
FAILURE
⎪ ⎪
⎩ ⎭
TERMINATE
⎧
ENABLED
⎨
⎩
DISABLED
⎧ ⎫
ENABLED
⎨ ⎬
⎩ ⎭
DISABLED
TIMEOUT time
USERNAME username
PASSWORD password
12-81
Port Commands
⎫
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎬
⎪
⎪
⎪
⎪
⎪
⎪
⎫
⎪
⎬
⎪
⎭
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎪
⎭