Command Reference
12.7.11 Set/Define Service Postscript
⎧
⎫
SET
⎨
⎬
SERVICE ServiceName POSTSCRIPT
⎩
⎭
DEFINE
If enabled, the SCS will assume there is a PostScript printer attached to the service ports and will try to
ensure a job is done before starting another. It will send a Ctrl-D to the attached device and wait for the new
printer to return a Ctrl-D before starting the job transfer. If this is not done, slower printers may lose new
jobs while interpreting the previous job. Setting PostScript mode is strongly recommended for all PostScript
queues.
Restrictions
Defaults
See Also
12.7.12 Set/Define Service PSConvert
⎧
⎫
SET
⎨
⎬
SERVICE ServiceName PSCONVERT
⎩
⎭
DEFINE
Controls whether the SCS will place a PostScript wrapper around each job. The SCS will try to detect if it
is already a PostScript job, in which case it would not add an additional wrapper.
See Also
12.7.13 Set/Define Service RTEL
⎧
⎫
SET
⎨
⎬
SERVICE ServiceName RTEL
⎩
⎭
DEFINE
Enables or disables RTEL access to the specified service.
Restrictions
Defaults
See Also
Requires privileged user status.
Disabled
Clear/Purge Service, page 12-101
Clear/Purge Service, page 12-101
⎧
ENABLED
⎨
⎩
DISABLED
Requires privileged user status.
Enabled
Clear/Purge Service, page 12-101
12-106
⎧
⎫
ENABLED
⎨
⎬
⎩
⎭
DISABLED
⎧
⎫
ENABLED
⎨
⎬
⎩
⎭
DISABLED
⎫
⎬
⎭
Service Commands