Define Ports Slip - Lantronix SCS Reference Manual

Command Reference
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
See Also

12.6.46 Define Ports SLIP

DEFINE PORTS PortList
The Enabled and Disabled parameters determine whether or not SLIP can be run on the specified port. The
Dedicated parameter devotes that port to SLIP mode.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
See Also
Requires privileged user status.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Disabled
DSR for Controlling Remote Logins, page 8-21
⎧
ENABLED
⎪
⎨
SLIP
DISABLED
⎪
ALL
⎩
DEDICATED
Requires privileged user status.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Dedicated
The specified port will automatically run SLIP when it is started. No other
protocol can be run on the port; it will continue to run SLIP until it is logged
out.
Disabled
Set/Define Ports SLIPdetect, page 12-88; Set SLIP, page 12-96; Show/
Monitor/List Ports SLIP, page 12-96; Starting PPP/Slip for Incoming
Connections, page 4-11
⎫
⎪
⎬
⎪
⎭
12-87
Port Commands