Lantronix SCS Reference Manual page 234

Command Reference
12.5.12.9 Set/Define 80211 Power
⎧ ⎫
SET
⎨ ⎬
80211 POWER
⎩ ⎭
DEFINE
Controls the card's transmit power settings. The numeric power setting specified must exactly match a value
supported by the card.
Any configuration changes you make with the above commands will not take place until you reboot the SCS
or issue the Set 80211 Reset command.
Restrictions
Errors
Parameters
Examples
See Also
12.5.12.10 Set/Define 80211 Region
⎧ ⎫
SET
⎨ ⎬
80211 REGION
⎩ ⎭
DEFINE
Sets the regulatory region under which you will operate the SCS. Users in the United States can leave this
at the default setting (FCC). Other users should set it to correspond with their region.
Any configuration changes you make with the above commands will not take place until you reboot the SCS
or issue the Set 80211 Reset command.
Restrictions
⎧ ⎫
DEFAULT
⎨ ⎬
⎩ ⎭
num
Requires privileged user status.
Only applies to the SCS200.
If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
Default
Sets the card to its default transmit power setting.
num
Enter a specific milliWatt power setting.
Local>> DEFINE 80211 POWER DEFAULT
Local>> SET 80211 RESET
Show 80211, page 12-48; 802.11 Configuration, page 2-11
⎧ ⎫
⎪ ⎪
FCC
⎪ ⎪
⎪ IC ⎪
⎪ ⎪
ETSI
⎨ ⎬
⎪ ⎪
SPAIN
⎪ ⎪
FRANCE
⎪ ⎪
⎪ ⎪
MKK
⎩ ⎭
Requires privileged user status.
Only applies to the SCS200.
12-30
IP/Network Commands