Lantronix SCS Reference Manual page 351

Command Reference
The success and failure settings control the time between calls. If the connection
Note:
worked, the SCS waits for the success delay to pass before attempting another
connection. If the connection did not work, the SCS waits for the failure delay to
pass.
Default
Set the default access parameter for the site.
If the default is enabled, connections are allowed except during the times
specified. If the default is disabled, connections are restricted except during the
times specified.
Clear
Remove a time range.
number
A time range to be removed. Time ranges are listed in numerical order.
Forcedial
Configures the site to dial at a particular time of day. If a time is assigned with
this command, the site will always attempt to create a connection at that
specified time, every day.
time
Enter a time for the Forcedial feature.
All
Remove all time ranges.
Forcedial
Creates a connection, every day, at the time set with the other parameters.
Session
Sets the total time, in seconds, that this site can be active before it is logged out.
Must be used in conjunction with the limit parameter.
limit
Specify a time range from 10 to 65,000 seconds. A setting of zero disables the
session limit.
Success
Specifies a delay after a successful connection before another connection will
be attempted. Must be used in conjunction with the seconds parameter.
Failure
Specifies a delay after a failed connection attempt before another connection
will be attempted. Must be used in conjunction with the seconds parameter.
seconds
A delay time of 1 to 65000 seconds.
Connection
Specifies the minimum amount of time, in seconds, after a connection drops or
fails before attempting to form another connection. Must be used in
conjunction with the seconds parameter.
12-147
Site Commands