Set/Define 80211 - Lantronix SCS Reference Manual

Command Reference

12.5.12 Set/Define 80211

After you enter an 80211 configuration command, you must reboot the unit for the changes to take effect.
You can also enter the Set 80211 Reset command for all configuration commands except the Set/Define
802.11 Enabled/Disabled command, which requires a reboot.
These commands are only valid on the SCS200.
Note:
12.5.12.1 Set/Define 80211 Enabled
⎧ ⎫
SET
⎨ ⎬
80211
⎩ ⎭
DEFINE
When 802.11 is enabled, the SCS checks for a compatible 802.11 wireless Ethernet PC card at startup and,
if one is present, uses the card instead of a wired Ethernet port. If no valid PC card is detected at startup, the
SCS uses the 10/100BASE-T network connection.
When 802.11 is disabled, the SCS will ignore an installed 802.11 card and will only look for a compatible
wired Ethernet connection.
You must reboot the SCS before those changes will take place.
Restrictions
Parameters
Defaults
See Also
12.5.12.2 Set/Define 80211 Antenna
⎧ ⎫
SET
⎨ ⎬
80211 ANTENNA
⎩ ⎭
DEFINE
SYNCH
Synchronize
⎧ ⎫
ENABLED
⎨ ⎬
⎩ ⎭
DISABLED
Requires privileged user status.
Only applies to the SCS200.
Enabled
Prompts the SCS to check for a compatible 802.11 wireless Ethernet
networking PC card at startup. If one is present, wireless networking will be
used instead of the wired Ethernet connection. You must reboot the SCS after
entering this command.
Disabled
Prompts the SCS to only look for a compatible 10/100BASE-T wired Ethernet
connection at startup. You must reboot the SCS after entering this command.
Enabled
Show 80211, page 12-48; 802.11 Configuration, page 2-11
⎧
RX list
⎨
⎩
TX DEFAULT
⎫
⎬
⎭
12-24
IP/Network Commands