Set/Define Server Login Password; Set/Define Server Name - Lantronix SCS Reference Manual

Secure console servers
Table of Contents

Advertisement

Command Reference

12.8.19 Set/Define Server Login Password

SET
SERVER LOGIN PASSWORD password
DEFINE
Specifies the password that is used to log in to the server from the serial ports or the network. If the password
is not given on the command line, you will immediately be prompted to enter the password, which will not
be displayed when typed.
The login password is only required on ports that have been Password Enabled.
Restrictions
Parameters
SCS passwords are case-independent, even when enclosed in quotes.
Note:
Defaults
Examples
See Also

12.8.20 Set/Define Server Name

SET
SERVER NAME ServerName
DEFINE
Specifies the name of the SCS. The name string must be in quotes if lowercase characters are used.
Restrictions
Parameters
Defaults
Examples
See Also
Requires privileged user status.
password
Enter a password of 16 or fewer characters.
"access"
Local>> SET SERVER LOGIN PASSWORD
Password> platyp (not echoed)
Verification> platyp (not echoed)
Local>>
Set/Define Server Incoming Password, page 12-119;
Login Password, page 8-10; Set/Define Ports Password, page -78
Requires privileged user status.
ServerName
Assign a name to the SCS, 16 alpahanumeric characters or less.
SCS_xxxxxx where xxxxxx represents the last 3 segments of the unit's
hardware address.
Local>> SET SERVER NAME "docserver"
Changing the Server Name, page 2-9
12-121
Server Commands

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SCS and is the answer not in the manual?

Table of Contents