Set/Define Ports Username - Lantronix SCS Reference Manual

Command Reference
Describes the type of device connected to the port.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Defaults
See Also

12.6.53 Set/Define Ports Username

⎧ ⎫
SET PORTS PortList
⎨ ⎬
⎩ ⎭
DEFINE
Used to specify a username for the port. When the username is defined, you will not be asked for one when
logging in to the port.
Restrictions
Parameters
In the absence of a PortList or the All parameter, the configuration will affect the
Note:
current port only.
Requires privileged user status to use this command on ports other than your
own.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
ANSI
VT100 compatible devices.
Softcopy
VT100 without clear screen or cursor controls.
Hardcopy
Deleted characters are echoed between backslashes; there is no cursor
movement.
Softcopy
Setting the Device Type, page 8-14
⎧
username
⎨
USERNAME
⎩
ALL NONE
Requires privileged user status to use this command on ports other than your
own. Secure users may not use this command.
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
username
A name of up to 16 characters in length, converted to all uppercase unless
enclosed in quotes.
None
Clears a current username.
12-91
⎫
⎬
⎭
Port Commands