Show Rs485; Show/Monitor Sessions - Lantronix SCS Reference Manual

Command Reference
The Modem Status option is of no use for remote access or no access ports.
Note:
Examples
See Also

12.6.61 Show RS485

SHOW RS485
Displays the current RS-485 networking settings, including wire mode, termination, and TXDrive.
Restrictions
See Also

12.6.62 Show/Monitor Sessions

⎧ ⎫
SHOW
⎨ ⎬
SESSIONS
⎩ ⎭
MONITOR
Displays information about the specified sessions.
Restrictions
Summary
Displays a one-line summary of information about the specified ports. The
information includes type of access, status, and services offered. The Summary
option shows the access type, any offered services, and the login status of the
port.
PPP
Displays information about the Point to Point Protocol's Link Control Protocol
on the specified ports.
Modem
Displays information about modem control and configuration strings on the
specified ports.
Status
The Modem Status option shows the last connect speed of the modem
connected to the specified port(s), and the last available Caller-ID information
for the port(s). Modem control must be enabled for this command to work.
Local> SHOW PORT ALL SUMMARY
Local> LIST PORT ACCESS DYNAMIC COUNTERS
Chapter 8, Chapter 8
Only applies to the SCS200.
Define Protocols RS485, page 12-93; RS-485 Configuration, page 8-15
PORT PortNum
ALL
You must be the privileged user to use the Monitor command.
Secure users cannot specify Port or All.
12-98
Port Commands