Lantronix SCS Reference Manual page 339

Command Reference
Defaults
Examples
See Also
BytesPerSecond
The precise bandwidth amount, up to 6,550,000 bytes per second. The server
will add ports until it reaches the specified amount.
BytesPerSecond is truncated to the nearest 100. For example, a setting of 3840
is truncated to 3800.
A BytesPerSecond value below of 99 or less truncates to zero, disabling
bandwidth.
Period
Sets the number of seconds (specified by the seconds parameter) used to
calculate average utilization statistics. The value is expressed as percent usage
over a period of time.
Holddown
Specifies the minimum amount of time, in seconds, after adding or removing
bandwidth to the remote site before bandwidth can be adjusted again. Must be
used in conjunction with the seconds parameter.
Adding bandwidth after it has been removed or removing bandwidth after it
has been added requires double the number of seconds. For example, if a
holddown value of 5 is specified, adding bandwidth after it has been removed
will require a 10 second delay.
Add and Remove: Disabled (utilization = 0).
Default: bring up one port.
Initial and Maximum: 100 bytes per second.
Period: 60 seconds.
HoldDown timer: 60 seconds.
Local>> DEFINE SITE irvine BANDWIDTH INITIAL 123
Local>> DEFINE SITE irvine BANDWIDTH ADD 50
Local>> DEFINE SITE irvine BANDWIDTH PERIOD 6
Define Ports PPP Multilink, page 12-81; Define Site Port Bandwidth, page 12-
143; Show/Monitor/List Sites Bandwidth, page 12-149; Bandwidth On
Demand, page 5-4
12-135
Site Commands