Lantronix SCS Reference Manual page 231

Command Reference
12.5.12.5 Set/Define 80211 ESSID
⎧ ⎫
SET
⎨ ⎬
80211 ESSID
⎩ ⎭
DEFINE
Configures the ESSID, which tells the SCS the name of the Extended Service Set (ESS) to which it belongs.
Setting an ESSID ensures that the SCS will stay on the desired network subsegment.
Any configuration changes you make with the above commands will not take place until you reboot the SCS
or issue the Set 80211 Reset command
Restrictions
Errors
Parameters
Defaults
See Also
⎧ ⎫
name
⎨ ⎬
⎩ ⎭
NONE
Requires privileged user status.
Only applies to the SCS200.
If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
name
Enter a string of up to 32 characters. If the string contains lowercase letters or
non-alphanumerics, it may need to be enclosed in quotes to be processed
properly.
None
If no ESSID string is set, the SCS will communicate with whichever Access
Point (AP) gives the strongest signal, regardless of ESS association. Setting the
ESSID to none allows the SCS to associate with any AP within range.
ESSID=None
Show 80211, page 12-48; 802.11 Configuration, page 2-11
12-27
IP/Network Commands