Configuring Snmp Credentials - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

2
23. Click OK on the Discover Setup dialog box.

Configuring SNMP credentials

1. Select Discover > Setup.
2. Select an IP address from the Available Addresses table.
3. Click Edit.
4. Click the SNMP tab.
5. Select the SNMP version from the SNMP Version list.
6. Specify the Read option by selecting Default 'public' or Custom.
7.
8. Specify the Write option by selecting Default 'private' or Custom.
9. If you selected Custom, enter the community string in the Custom and Confirm Custom fields.
10. If you are configuring a 256-Port director, select the Configure for 256-Port_Director_Name
FIGURE 22
11. Enter a user name in the User Name field.
40
NOTE
Professional Plus edition can only discover 4 fabrics.
The Discover Setup dialog box displays.
The Address Properties dialog box displays.
•
If you selected v1, continue with step 6.
•
If you select v3, the SNMP tab displays the v3 required parameters. Go to step 10.
To discover a Virtual Fabric device, you must configure SNMP v3 and your SNMP v3 user
account must be defined as a Fabric OS switch user.
If you selected Custom, enter the community string in the Custom and Confirm Custom fields.
Go to step 21.
check box.
•
If you selected Configure for 256-Port_Director_Name, go to step 14.
•
If you did not select Configure for 256-Port_Director_Name, continue with step 11.
Address Properties dialog box (SNMP Tab - v3)
DCFM Professional Plus User Manual
53-1001774-01