Snmp Configuration; Setting Snmp Trap Levels; Changing The Systemgroup Configuration Parameters; Setting Snmpv1 Configuration Parameters - Brocade Communications Systems SN3000B Administrator's Manual
Brocade web tools administrator's guide - supporting fabric os v7.0.0 (53-1002152-01, march 2012)
Hide thumbs
Also See for SN3000B:
- Command reference manual (1132 pages) ,
- Reference (966 pages) ,
- Administrator's manual (128 pages)
Table of Contents
Advertisement
16
SNMP configuration
4. Use the Switch Policy Authentication Mode option to select the authentication policy.
SNMP configuration
This section describes how to manage the configuration of the SNMP agent in the switch. The
configuration includes SNMPv1 and SNMPv3 configuration, accessControl, and systemGroup
configuration parameters.
Access is read-only if you do not have admin or security admin authority.
For more information, refer to the snmpConfig command in the Fabric OS Command Reference.
Setting SNMP trap levels
To set SNMP trap levels, perform the following steps.
1. Open the Switch Administration window as described in
2. Select the SNMP tab.
3. Select a trap level for a recipient from the corresponding Trap Level menu in the SNMPv1 and
4. Click Apply.
Changing the systemGroup configuration parameters
To change the systemGroup configuration parameters, perform the following steps.
1. Open the Switch Administration window as described in
2. Select the SNMP tab.
3. Enter a contact name, description, and location in the SNMP Information section.
4. Optional: Select the Enable Authentication Trap check box to allow authentication traps to be
5. Click Apply.
Setting SNMPv1 configuration parameters
To set SNMPv1 configuration parameters, perform the following steps.
1. Open the Switch Administration window as described in
2. Select the SNMP tab.
194
window"
on page 33.
SNMPv3 sections.
The level you select identifies the minimum event level that prompts a trap.
NOTE
Adding or editing the user name can be done only through the CLI and by selecting a user
name from the User Name menu in the SNMPv3 section.
window"
on page 33.
sent to the reception IP address.
window"
on page 33.
"Opening the Switch Administration
"Opening the Switch Administration
"Opening the Switch Administration
Web Tools Adminstrator's Guide
53-1002152-01
Advertisement
Table of Contents
