Avaya Communication Manager Administrator's Manual page 1212

Screen Reference
Send Connected Number
Appears if the QSIG Value-Added field on the Trunk Group screen is n. Specifies if the
connected party's number is sent on incoming or tandemed ISDN calls. Valid entries are y, n, or
r (restricted). If y is entered, the ISDN Numbering - Public/Unknown Format screen is
accessed to construct the actual number sent, or the ISDN Numbering-Private screen (based
on the Numbering Format field) is used. If the value is r, the connected number is sent
"presentation restricted." The Send Connected Number field must be set to y in order for the
Calling Party Number of an incoming ISDN call to display at the transferred-to station after a
QSIG transfer operation.
When Send Connected Number is n, an incoming number is not tandemed out again.
Similarly, when Send Connected Number is r (restricted), an incoming number is marked
restricted when it is tandemed out again. This applies to all Supplementary Service Protocols.
Note:
The AT&T Switched Network Protocol does not support restricted displays of
Note:
connected numbers. Therefore, if you administer the 1a country-protocol/
protocol-version combination on the DS1 screen, you should not administer the
Send Connected Number field to r (restricted) on the ISDN Trunk Group
screen, as this causes display problems.
The ISDN Numbering - Public/Unknown Format screen overrides the Send
Connected Number field entry for any administrable block of extensions.
Network Call Redirection
Administrable if, on the System-Parameters Customer-Options screen, the ISDN-PRI or
ISDN-BRI Trunks field is y, the ISDN Network Call Redirection field is y, and on the ISDN
Trunk Group screen, the Supplementary Service Protocol field is c or g. Whenever the
Supplementary Service Protocol field is changed, this field resets to none to prevent an
inadvertent incorrect value.
Valid entries
ANSI-transfer
Nortel-transfer
deflect
none
1212 Administrator Guide for Avaya Communication Manager
Usage
Indicates standard ANSI encoding functionality. Allowed only if the
Supplementary Service Protocol field is g.
Indicates non-standard ENCT functionality. Allowed only if the
Supplementary Service Protocol field is g.
Indicates network call redirection. Allowed only if the Supplementary
Service Protocol field is c.
No redirection (default).