Avaya Communication Manager Administrator's Manual page 1309

The ANI Prefix, Default ANI, and Collect All Digits Before Seizure fields appear only when
the value of the Outgoing Call Type field is group-ii-mfc or mfe.
If Collect All Digits Before Seizure is y, Overlap Sending on Link-to-Link Tandem Calls
and Convert First Digit End-of-ANI are not displayed.
Default ANI
This field appears only when Outgoing Call Type is group-ii-mfc or mfe.
Valid entries
2 to 15
blank
ANI Prefix
This field appears only when Outgoing Call Type is group-ii-mfc or mfe.
Valid entries
1 to 6 digits or
blank
Backward Cycle Timer (sec)
Appears when the Incoming Call Type field is mfe.
Valid entries
1 to 255
Usage
Enter the PBX identification number that is sent to the CO when ANI is
requested (by the CO) on a particular call but is not available, such as on
tandem tie trunk calls.
Use for tandeming. If this field is blank, you must enter a value in the
ANI-Not-Available field.
Usage
Enter the prefix to apply to an extension when ANI is sent to the CO.
Usage
Enter the number of seconds to wait to send the check frequency after
receiving an MFE signal.
Multifrequency-Signaling-Related Parameters
Issue 2.1 May 2006 1309