Avaya Communication Manager Administrator's Manual page 1322

Screen Reference
ANI Not Available
You must enter a value if the ANI for PBX field is blank.
Valid entries
1 to 15 or blank
Field descriptions for page 3
The fields shown on Page 3 of the Multifrequency-Signaling-Related System Parameters
screen define the meaning of MFC tones for calls originated at the CO. See
I, II, A, and B signals
Incoming Call Type field is group-ii-mfc or non-group-ii-mfc.
When the screen initially appears, either of two sets of default values is possible. One set is for
the group II call type; the other set is for non-group II call type. In each set, the default value for
each field is set to the most common value.
The Multifrequency-Signaling-Related Parameters screen shows the defaults when the
Incoming Call Type field is group-ii-mfc. A variation appears if Incoming Call Type is
non-group-ii-mfc. When Incoming Call Type is non-group-ii-mfc, group II and group B
columns do not appear.
1322 Administrator Guide for Avaya Communication Manager
Usage
Enter the number of the incoming and outgoing ANI-Not-Available signals.
Communication Manager outpulses the End-of-Dial backward signal
when the ANI-Not-Available forward signal is received on incoming calls.
Communication Manager outpulses the ANI-Not-Available forward signal
to the CO on outgoing calls where ANI is not possible.
on page 1329 for more information. This screen appears only if the
Definitions of Group