System Parameters Cdr (Call Detail Recording); System Parameters Country-Options - Avaya Communication Manager Administrator's Manual

Screen Reference

System Parameters CDR (Call Detail Recording)

See CDR System

System Parameters Country-Options

This screen implements parameters associated with certain international (including North
American) call characteristics. You cannot change this screen. See your Avaya technical
support representative if you want to modify any of the values here.
The following table shows the country codes that are used in Communication Manager. The
Country Code is used by various fields and screens throughout the system.
Country code table
Code Country
1 United States, Canada,
Korea, India
2 Australia, New Zealand
3 Japan
4 Italy
1514 Administrator Guide for Avaya Communication Manager
Parameters.
Ringing Signal Voltage, Frequency, and Cadence
300v peak to peak, < 200v peak to ground ; < 70 Hz ; < 5s
on > 1s off
Korea : 20 Hz , 75 to 85 Volts (AC) , Cadence : 1 sec on , 2
sec off
75 +/- 20 VRMS superimposed on 48 V dc at 14.5 to 55 Hz
with cadence 400ms on, 200ms off , 400ms on, 2000ms off
New Zealand : Ringing voltage at the customer's premises
not less than 38 V rms (25Hz) on top of 50V d.c; 20 Hz;
400ms on, 200ms off, 400ms on, 2000ms off
75 VRMS(75-10VRMS <= x <= 75+8VRMS), 15-20 Hz and
cadence of 1second on and 2 seconds off is required
20 to 50 Hz, 26 to 80 Volts rms superimposed on 48 V dc,
1 sec on, 4 sec off
ETSI countries: 30 Volts rms, superimposed on a DC
voltage of 50 Volts, 25 or 50 hz, cadence of 1 sec on, 5 sec
off
1 of 4