Avaya Communication Manager Administrator's Manual page 979

Self Station Display Enabled
Use this field to control the use of the inspect button for digital display telephones.
Self Station Display allows a user to display the primary extension associated with a digital
display telephone. There are two methods: (1) enter a feature access code (FAC), and (2) use
the inspect button. In either case, the display shows the primary extension associated with the
telephone where the FAC or normal or exit button is entered. In the case of the FAC, the
display continues until a display-altering event occurs (for instance, going on-hook or receiving
an incoming call). In the case of the inspect button, the display continues until the user presses
the normal or exit button or until a display-altering event occurs.
Valid entries
y
n
Trunk-to-Trunk Transfer
Regulations in some countries control the settings for this field. See your Avaya technical
support representative for assistance.
Valid entries
all
restricted
none
Type
This field appears when Music/Tone on Hold is set to music.
Note:
If the Tenant Partitioning field on the Optional Features screen is set to y, you
Note:
cannot administer the Music/Tone on Hold field. If the Tenant Partitioning field
on the Optional Features screen set to y, you must use the
screen to assign music to a port.
Usage
The primary extension does display when the inspect button is pressed.
The extension does not display when the inspect button is pressed.
Usage
Enter all to enable all trunk-to-trunk transfers. This allows telephone users
to set up trunk-to-trunk transfer, go on-hook without disconnecting the
call, and forward the call to a remote location. This value is required for
SIP Enablement Services (SES) support.
Enter restricted (restricted public) to restrict all public trunks (CO, WATS,
FX, CPE, DID, and DIOD).
Enter none to restrict all trunks (except CAS and DCS) from being
transferred.
Feature-Related System Parameters
Music Sources
Issue 2.1 May 2006 979